Effect of Print Orientation and Infill on the Charpy Impact Strength of FDM-Printed ABS

Authors

  • Gábor Kerényi Institute of Mechanical Engineering and Technology, Óbuda University, József körút 8., Budapest, 1081, HUNGARY
  • Balázs Mikó Institute of Mechanical Engineering and Technology, Óbuda University, József körút 8., Budapest, 1081, HUNGARY

DOI:

https://doi.org/10.33927/hjic-2026-31

Keywords:

additive technology, FDM printing, ABS material, charpy impact test

Abstract

The paper presents an experimental investigation of the impact strength of FDM-printed specimens. Charpy impact test specimens were prepared according to ISO 148 geometry. During the investigation, the impact energy of the test specimens was measured, the fracture surfaces were examined, and the obtained data were evaluated using analytical methods. Following the evaluation, the optimal orientation was determined, and, based on further measurements, the optimal infill associated with this orientation was identified. The article also contains data related to the reproducibility of the measurement and the relevant literature background. The results show that the F90 orientation (parallel to the Y axis) possesses the optimal energy absorption. Its average impact energy value is 0.76 J. Among specimens printed in the F90 orientation with different infill percentages, 30% infill resulted in the highest impact energy.

Downloads

Published

2026-11-19

How to Cite

Kerényi, G., & Mikó, B. (2026). Effect of Print Orientation and Infill on the Charpy Impact Strength of FDM-Printed ABS. Hungarian Journal of Industry and Chemistry, 54(2), 87-94. https://doi.org/10.33927/hjic-2026-31

Most read articles by the same author(s)