Analysis of Formed Chips in the Case of Turning Different Polymer Materials

Authors

  • Ádám Sarankó
  • Gábor Kalácska
  • Róbert Zsolt Keresztes

DOI:

https://doi.org/10.33927/hjic-2021-25

Keywords:

chip formation, polymer materials, turning

Abstract

In this paper, turning input parameters were defined for 12 different polymer materials that can be used in technical practices. Our goal was to determine turning input parameters where chip formation is favourable or continuous chips do not cause any problems. Our tests included the examination of detached chips and the values of the average surface roughness of the machined surfaces.

Author Biographies

  • Ádám Sarankó

    Institute of Technology, Hungarian University of Agriculture and Life Sciences, Páter Károly u. 1, Gödöllő, 2100, HUNGARY

  • Gábor Kalácska

    Institute of Technology, Hungarian University of Agriculture and Life Sciences, Páter Károly u. 1, Gödöllő, 2100, HUNGARY

  • Róbert Zsolt Keresztes

    Institute of Technology, Hungarian University of Agriculture and Life Sciences, Páter Károly u. 1, Gödöllő, 2100, HUNGARY

Downloads

Published

2022-02-08

Issue

Vol. 49 No. 2 (2021): Hungarian Journal of Industry and Chemistry

Section

Articles

How to Cite

Analysis of Formed Chips in the Case of Turning Different Polymer Materials. (2022). Hungarian Journal of Industry and Chemistry, 49(2), 71-75. https://doi.org/10.33927/hjic-2021-25