Characteristics of White Ink for a Garment Identification Numbering Printer Using Mixed Surfactants
DOI:
https://doi.org/10.33927/hjic-2026-32Keywords:
mixed surfactants, numbering printer, cut piece, identification number, white inkAbstract
This study was conducted to manufacture white ink for a numbering printer used for garment identification in the production of clothing products using mixed surfactants and to improve its characteristics. The ink used titanium dioxide as a colorant and paraffin oil as a vehicle. The ratio of colorant to vehicle was 1:3. Among the lipophilic surfactants Span-40, Span-60, Span-80, and Span-85 and the hydrophilic surfactants Tween-80 and OP-10, the most suitable lipophilic and hydrophilic surfactants for ink manufacture were selected, and experiments were conducted to determine the contents that best improved the ink characteristics. Span-60 (sorbitan monostearate) was found to be the most suitable lipophilic surfactant, and Tween-80 (polyoxyethylene sorbitan monooleate) was the most suitable hydrophilic surfactant. When the content of Span-60 was 0.2%, the dispersion stability was the highest at 192 h, and when the content of Tween-80 was around 0.4%, washability was the highest. To improve the number identification performance of the ink, rosin was used, and when the content was 0.9% or more, numbers could be identified even on light-colored fabrics. The characteristics of the finally manufactured ink were as follows: the average particle size was 0.603 μm, the viscosity was 631.4 mPa·s, and the structural recovery time was 1.5 to 1.7 s.

